Arkusz

 Powrót    Drukuj

Dane techniczne

Informacje dodatkowe

Stegherr KSF-2/E-4
-----------------------------------------
The KSF-2/E-4 cross bar milling machine is equipped with a convenient, menu-
driven computer control. After entering the programs, cross bar connections for
windows, doors, furniture, partition walls, radiator covers, etc. can be
realized with minimal setup and operating time. The cross bar milling is
computer-controlled with 3 special milling cutters that run and move
simultaneously. An additional milling unit mills the change groove from the
front. The corresponding distances can be stored in programs. The workpieces
are fed in automatically.

Control: BECKHOFF CP7703-1048-0030
Installation dimensions approx. (LxWxH): 6,900 x 1,050 x 1,330 mm
Weight approx. 1,000 kg

Equipment of the machine
according to the original order confirmation:
----------------------------------------
Item 1: Cross-bar milling machine STEGHERR TYPE KSF-2E
with 3 milling units, without tools) with electronic positioning control
for
equal and different milling distances within a workpiece and
monitor.
Special milling machine for the efficient production of cross-bar connections
with
electronic positioning control (standard length of the stop for
workpieces up to 2200 mm, accuracy +/- 0.2 mm). The milling is carried out by
an upper and lower milling unit, and the flattening by a third milling unit in
one operation. The feed rate of the milling group is infinitely adjustable. The
entire milling group moves into the clamped, stationary workpiece. The height
of the upper and lower tool sets can be adjusted individually. This means that
the machine can be converted to a different wood thickness very quickly. The
tools are driven by two three-phase motors, each with 1.1 kW. The distances
between the desired millings and their number are entered into the positioning
control and saved. The total number of workpieces to be processed is also typed
in. Programming the positioning control is possible without any special
knowledge. Voltage Europe: 400V (+/-10%)/3Ph/50Hz

Item 2: Stop extension 1 m

Item 3: Length detection
The length of the part that is pushed in for processing from the NC stop is
determined by a sensor. How it works:
When the workpiece passes the sensor, it sends a signal to the control. At this
moment, the control looks at the position of the NC stop and can determine the
length of the part there

Item 4: 4th milling unit
This additional grooving unit makes it possible to machine vertical and
horizontal rungs without turning them by 180°.
This ensures that the visible side can be milled completely tear-free.

Pos. 5: Counter package with 2 counter-rotating spindles
including servo axis and adjustment slide of the counter bearing
for the adjustment of different tool diameters

Pos. 6: Saw unit with vertical stroke
for cutting to length and cutting at an angle the lattice profiles and glass
strips
with 3 adjustable cutting angles -45/90/+45 degrees

Pos. 7: Counter tools for counter unit with 2 spindles

Pos. 8: Tool set for 3 milling units, adjustment range 4.2 - 7.5 mm
- two-part, adjustable profile cutters
- adjustable groove cutter
- intermediate rings
- cutter bushings
- setting gauge and dial gauge

Pos. 9: groove set for 4th milling unit

Pos. 10: saw blade

Pos. 11: steel sheets with magnetic fastening for glass strips

(technical information according to manufacturer - without warranty!)